Makita DDF481 Technical Information page 5

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -2. Gear assembly, Rotor, Stator assembly, Speed change lever assembly (cont.)
(4) Assemble Motor section with Gear assembly and Speed change lever assembly to Housing L at a time.
And assemble Switch and F/R change lever to Housing L. (Fig. 18) Then, assemble Housing R to Housing L.
(5) Assemble Rear cover to Housing set. (Figs. 19 and 9) and tighten nine PT3x16 Tapping screws to fasten Housing L,
Housing R and Rear cover.
Fig. 18
Make sure that two Leaf springs
are set in place in advance.
Fit the protrusions of Housing L
into the depressions of Stator
complete
F/R Change lever
Fig. 19
Depression
in Rear cover
Speed change lever assembly
Leaf spring (2 pcs.)
Terminal of Stator must be on the center line of Motor section and Gear assembly.
prong portion
projection
Other side viewed from Housing L
Before assembling Switch to Housing L,
fit the prong of F/R change lever to
the projection of Switch.
Protrusion on
Fit the depression in Rear cover into
Housing R
the protrusion on Housing R.
P 5/ 11
Depressions