Makita BHS630 Technical Information page 3

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3]-1. Base
DISASSEMBLING
Base can be separated from the machine as drawn in Figs. 2 and 3.
Fig. 2
1. Remove M6x20 Thumb screw, Spring washer 6,
and Flat washer 6 from Angular guide side and
Depth guide side.
2. Remove M6x6 Hex Socket Head Set Screw
from Angular guide side and Depth guide side.
M6x6 Hex socket head set Screw
M6x20 Thumb
screw
Spring
Flat
washer 6
washer 6
Fig. 3
Remove the parts drawn below from Base.
And then, replace the Base with the new one.
M4x8 Pan head screw
Lock lever
Torsion spring 11
Base
ASSEMBLING
Take the reverse step of Disassembling. Refer to Fig. 3, Fig. 2.
Note in Assembling
1. After mounting Lock lever, its adjustment is required to obtain the correct lock position for guide rule, mounted.
to Base. See "[3]-2. Lock Lever" .
2. After mounting Base to the machine, adjustment of angle of saw blade to the Base is required.
See "[4] Adjustment"
M6x20 Thumb
screw
Spring
washer 6
Flat
washer 6
Shoulder pin 6-7
Do not forget to remove M6x8 Hex socket head set screw for
adjusting the angle of saw blade from the reverse side of Base.
Top guide
Lock lever
Torsion
spring 11
3. Remove Shoulder pin 6-7.
Now Base complete is separated
from the machine.
Base
M6x8 Hex socket head
set screw
P 3/ 16