Grizzly G0453W Owner's Manual page 21

7. Attach top and bottom of dust hood to planer
with (6) pre-installed M6-1 x 12 flange bolts
(see Figure 18).
3 of 6
Figure 18. Dust hood attached
(Model G0453W shown).
8. G0453W & G0454W Only: Mount magnetic
switch assembly to side of headstock with
(2) pre-installed M6-1 x 12 flange bolts (see
Figure 19).
Figure 19. Magnetic switch installed
(Models G0453W and G0454W).
G0453W/ZW–G0454W/ZW (Mfd. Since 05/16)
9. G0453W & G0453ZW Only: Remove two
pre-installed cap screws and rear return
roller bracket shown in Figure 20. Mount rear
return roller between brackets, then re-install
cap screws.
Note: Models G0453W & G0453ZW ship
with the rear return roller as separate invento-
ry because for these models, the return roller
blocks access to the dust hood fasteners.
Therefore, with these models, the rear return
roller must be installed AFTER the dust hood.
Rear Return
Roller
Figure 20. Return roller bar installed.
10. Attach foot-pedal caster assembly to bot-
tom of machine using (3) M8-1.25 x 50 cap
x2
screws, (3) 8mm lock washers, (6) 8mm
flat washers, and (3) M8-1.25 hex nuts (see
Figure 21).
Figure 21. Attaching foot-pedal caster assembly
x 3
to bottom of machine.
x 2
Bracket
-19-