Makita TD0101 Technical Information page 14

W
iring diagram
Fig. D-6
Wiring around Holder arm
Guide Field lead wires (purple, orange)
inside the rib of Holder arm to avoid
pinching between Housing set (R) and
Holder arm.
Holder arm
rib of
Holder arm
Wiring of Field
lead wires
Fix Field lead wire (red) with
Lead wire holders on Switch.
Noise suppressor
Terminal block
110 - 127V area
Except UK
Rib
Noise suppressor is not
used for some countries.
Put Insulated connector
into the area which is
surrounded by Ribs.
TD0101F
110V for UK
rib
rib
Wiring of Lead wire (brown or
black) of Power supply cord
Through the route between the following
ribs, guide the above lead wire to Switch.
* ribs for setting Noise suppressor
* ribs for setting Terminal block
Wiring of Lead wire (orange)
of left Brush holder and
Field lead wire (white)
Fix field Lead wire (white)
with Lead wire holder and Ribs.
Lead wire (orange)
of left Brush holder
Route Lead wire (orange)
of left brush holder by ribs.
Wiring of Noise suppressor's
Lead wires
Guide the Lead wires of Noise suppressor
between ribs.
* Lead wire (white) to Switch
* Lead wire (black) to LED circuit
Line filter
(if used)
Pass Lead wires of Power
supply cord through Line filter
if necessary.
P 14/ 14
Field lead
wire (white)
rib
Lead wire
holder on
Switch