Operating The Machine In System Management Mode; When Department Id Management Is Enabled And User Id Management Is Disabled - Canon imageRUNNER 2545i System Settings Manual

7
To cancel storing the System Manager Settings, press [Cancel].
NOTE
If you make a mistake when entering the password, press
correct password.
8
Press

Operating the Machine in System Management Mode

This section describes how to operate the machine in the System Management
mode.
NOTE
• When the operation is complete, be sure to press
System Management mode.
• The machine automatically logs out of the System Management mode after the Auto
Clear time has elapsed. For details about the Auto Clear mode, see Chapter 3,
"Configuring the Machine's Basic Settings," in the Reference Guide.
When Department ID Management Is Enabled and User ID
Management Is Disabled
When Department ID Management is enabled, the System Manager ID is handled as one of
the departments. Follow the procedure below to log in as the System Manager.
(Reset) to return to the top screen.
Press [System Password] ➞
enter a number (up to seven
digits) using -
keys) ➞ press [OK].
You cannot store a password that only
consists of zeros, such as <0000000>.
If you enter fewer than seven digits, the
machine stores the password with leading
zeros.
Example: If <02> or <002> is entered,
<0000002> is stored.
(Clear) ➞ enter the
(Log In/Out) to log out of the
Setting System Management Mode
(numeric
1
1-7