Makita VC3510 Instruction Manual page 13

For use with power tool (fig. "A5").
- Selector switch
- Power switch
The appliance runs in synch with the power tool.
With switch "B" in position
( ) the self-cleaning filter function is activated.
- When the appliance is switched off, it will continue to run for 8÷10 seconds, then the self-
cleaning filter function will begin.
- To start the self-cleaning filter function manually, press the orange switch
(fig. "A6").
CAUTION: When switch
bled.
4
.....
CONNECTING A POWER TOOL TO THE VACUUM CLEANER
(fig. "A7" - "A8").
- Plug the power tool into the socket on the motor unit (A).
- Plug the vacuum into the power supply (B).
CAUTION: The plug is designed for power tools with a maximum rating of 2000 W
NEVER plug in power tools with a higher rating.
NEVER plug more than one power tool into the socket on the motor unit.
B - FILTER SYSTEMS
1
..... USING THE DUST BAG
Use the dust bag only when the filter cartridge is installed.
CAUTION:
- Insert the paper filter bag in the waste drum (fig. "B1").
- Fit the plastic flange (x) onto the air inlet connector (y).
Be careful not to damage the bag (fig. "B2").
- Use the bag to remove dirt more hygienically.
2
.....
TIPS FOR USING THE DUST BAG
CAUTION: Avoid using the bag for sharp or damp materials.
- Change the bag when vacuumed material fills approx.
3/4 of its capacity.
- The bag should not be reused, always replace the used
bag with a new one.
- Always keep a spare pack of dust bags handy.
in "AUTOMATIC" position
:
I = Appliance on
: in position
(indicator light "C" on)
, when switch ("A") is set to the "AUTOMATIC" position
is in position "O", the (Self Cleaning Filter) function is disa-
pack code
( 83 133B8K *)
- 13 -
( ).
Cod.
83 133B8K *
EN
("D")
*
Pack code