Speed Change; Optional Accessory - Makita DUB362 Instruction Manual

To start the tool, simply pull the switch trigger. Tool
speed is increased by increasing pressure on the switch
trigger. Release the switch trigger to stop.
1
1
015479
For continuous operation, pull the switch trigger, push in
the lock button and then release the switch trigger.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.

Speed change

1
015477
The maximum air volume can be adjusted just by
turning the adjusting dial. This can be done even while
the tool is running. The dial is marked 1 (lowest) to 6
(highest).
NOTICE:
The speed adjusting dial can be turned only as far
as 6 and back to 1. Do not force it past 6 or 1, or
the speed adjusting function may no longer work.
When working in a high temperature circumstance,
the tool may be stopped because of the overheat
protection system. In that case let the tool cool
down. Avoid setting to speed 6 (highest) in high
temperature circumstances.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
1. Lock button
1. Adjusting dial
7
Installing the long nozzle
2
1
015480
To install the long nozzle:
1. Align the small projection of the housing with the
groove of the long nozzle.
2. Slide in the long nozzle, and turn it clockwise until
the triangle markings on the long nozzle and the
housing meet each other.
015481
The length of the nozzle can be adjusted by changing
the locking position.
Installing the shoulder strap

(optional accessory)

015482
Hook the shoulder strap onto the hanger of the tool.
Before use, adjust the length of strap so that it is easy to
work with it.
1. Long nozzle
2
2. Triangle marking