Makita DUB362 Instruction Manual page 4

17. Never point the nozzle at anyone in the vicinity
when using the blower.
18. Warning - Electric shock could occur if used on
wet surfaces. Do not expose to rain. Store
indoors. Avoid using the machine in bad weather
conditions especially when there is a risk of
lightning.
19. Never block suction inlet and/or blower outlet.
Do not block suction inlet or blower outlet to
•
clean up in dusty areas.
Do not use the blower with a tapered nozzle
•
smaller than the original one, such as a new
nozzle obtained
diameter-reduced hose or smaller hose to the
nozzle top end.
Do not Use the blower to inflate balls, rubber
•
boat or the similar.
Increased motor revolution may cause dangerous
fan breakage and result in serious personal injury.
Heated motor and control circuit may cause a fire.
20. Do not operate the blower near open window, etc.
21. Operating the blower only at reasonable hours is
recommended - not early in the morning or late at
night when people might be disturbed.
22. To reduce damage from vibration and/or damage
to the ears, operate the machine at low speed if
possible and limit the time of operation.
23. Using rakes and brooms to loosen debris before
blowing is recommended.
24. It is recommended to slightly dampen surfaces in
dusty conditions or use mister attachment
available on the market.
25. It is recommended to use the long nozzle so the
air stream can work close to the ground.
26. Young children should be supervised to ensure
that they do not play with the blower.
27. Do not insert fingers or other objects into suction
inlet or blower outlet.
28. Prevent unintentional starting. Ensure the switch
is in the off-position before connecting to power
source and/or battery pack, picking up or carrying
the tool. Carrying machines with your finger on
the switch or energising machines that have the
switch on invites accidents.
29. Make sure that there are nobody around you
when you work at high places.
Maintenance and storage
30. Keep all nuts, bolts and screws tight to be sure
the machine is in safe working condition.
31. Replace worn or damaged parts.
32. Use only genuine
accessories.
33. Store the machine only in a dry place.
by attaching an extra
replacement parts
Battery tool use and care
34. Recharge only with the charger specified by the
manufacturer. A charger that is suitable for one
type of battery pack may create a risk of fire when
used with another battery pack.
35. Use power tools only with specifically designated
battery packs. Use of any other battery packs
may create a risk of injury and fire.
36. When battery pack is not in use, keep it away
from other metal objects, like paper clips, coins,
keys, nails, screws or other small metal objects,
that can make a connection from one terminal to
another. Shorting the battery terminals together
may cause burns or a fire.
37. Under abusive conditions, liquid may be ejected
from the battery; avoid contact. If contact
accidentally occurs, flush with water. If liquid
contacts eyes, additionally seek medical help.
Liquid ejected from the battery may cause
irritation or burns.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity with product (gained
from repeated use) replace strict adherence to safety
rules for the subject product. MISUSE or failure to
follow the safety rules stated in this instruction
manual may cause serious personal injury.
IMPORTANT SAFETY
INSTRUCTIONS
FOR BATTERY CARTRIDGE
1. Before using battery cartridge, read all
instructions and cautionary markings on (1)
battery charger, (2) battery, and (3) product
using battery.
2. Do not disassemble battery cartridge.
3. If operating time has become excessively
shorter, stop operating immediately. It may
result in a risk of overheating, possible burns
and even an explosion.
4. If electrolyte gets into your eyes, rinse them
out with clear water and seek medical
attention right away. It may result in loss of
your eyesight.
5. Do not short the battery cartridge:
(1) Do not touch the terminals with any
and
conductive material.
(2) Avoid storing battery cartridge in a
container with other metal objects such
as nails, coins, etc.
4
ENC007-9