Makita HR3540C Instruction Manual
Combination hammer
Hide thumbs
Also See for HR3540C:
- Instruction manual (56 pages) ,
- Technical information (20 pages) ,
- Instruction manual (56 pages)
Related Manuals for Makita HR3540C
Summary of Contents for Makita HR3540C
- Page 1 INSTRUCTION MANUAL Combination Hammer HR3540C HR3541FC 008719 DOUBLE INSULATION WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
-
Page 2: Specifications
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice. • Specifications may differ from country to country. • Weight according to EPTA-Procedure 01/2003 END201-5 For Model HR3540C ENG102-3 Symbols Noise The following show the symbols used for the equipment. -
Page 3: General Power Tool Safety Warnings
Electrical safety Makita Corporation responsible Power tool plugs must match the outlet. Never manufacturer declare that the following Makita modify the plug in any way. Do not use any machine(s): adapter plugs with earthed (grounded) power Designation of Machine: tools. Unmodified plugs and matching outlets will Combination Hammer reduce risk of electric shock. - Page 4 When operating a power tool outdoors, use an must be repaired. extension cord suitable for outdoor use. Use of 20. Disconnect the plug from the power source a cord suitable for outdoor use reduces the risk of and/or the battery pack from the power tool electric shock.
-
Page 5: Functional Description
FUNCTIONAL DESCRIPTION highly recommended that you wear a dust mask and thickly padded gloves. Be sure the bit is secured in place before CAUTION: operation. Always be sure that the tool is switched off and • Under normal operation, the tool is designed unplugged before adjusting or checking function on to produce vibration. -
Page 6: Torque Limiter
Speed change Rotation only 1. Lock button 1. Adjusting dial 2. Change lever 3. Pointer 008600 008538 For drilling in wood or metal, materials, etc., depress the The revolutions and blows per minute can be adjusted lock button and rotate the change lever so that the just by turning the adjusting dial. -
Page 7: Indicator Lamp
Indicator lamp Installing or removing the bit 1. Power-ON 1. Bit shank indicator lamp 2. Bit grease (green) 2. Service indicator lamp (red) 008541 003150 The green power-ON indicator lamp lights up when the Clean the bit shank and apply bit grease before installing the bit. tool is plugged. -
Page 8: Operation
clogged with chips or particles. Instead, run the tool at an idle, then remove the bit partially from the hole. By The bit can be secured at 24 different angles. To change repeating this several times, the hole will be cleaned out the bit angle, depress the lock button and rotate the and normal drilling may be resumed. -
Page 9: Maintenance
• the like. Discoloration, deformation or cracks may result. Lubrication CAUTION: This servicing should be performed by Makita • 008603 Authorized or Factory Service Centers only. This tool requires no hourly or daily lubrication because it has a grease-packed lubrication system. However, it is... - Page 10 Wipe out the old grease inside and replace with a fresh attachment for its stated purpose. grease (30 g). Use only Makita genuine hammer grease If you need any assistance for more details regarding (optional accessory). Filling with more than the specified these accessories, ask your local Makita Service Center.
- Page 12 Makita Corporation Anjo, Aichi, Japan 884815C227...