Makita PTM0900 Operator's Manual page 96

10
EN
with the hole on the shaft and insert the pin (3) using a hammer. Make sure the end
comes right through to the opposite side.
NOTE
driver of the same size as the pin when hammering it through the hole.
3.3 FITTING THE SEAT
Mount the seat (1) on the plate (2) using the
screws (3).
3.4 MOUNTING THE FRONT BUMPER
(if provided)
Mount the front bumper (1) on the bottom of
the frame (2) using the four screws (3).
3.5 ASSEMBLY AND CONNECTING THE BATTERY
The battery (1) is housed in the
engine compartment, covered by
a guard (2) and secured by a
clamp (3).
To remove the battery unscrew
the nut (4), remove the guard (2)
and loosen the clamp (3) pushing
To avoid damage to the steering wheel, use a punch or a screw-
UNPACKING AND ASSEMBLY
2
3 3
1
1
2
3
4
1
2
1