Honeywell MAXPRO Operator's Manual page 27

In the above figure:
MAXPRO NVR 1 and MAXPRO NVR 2 have the default port numbers, 20007, 26026, 10000
configured for the following services respectively.
In the Router's Port Forwarding table, the default ports numbers for these services are
mapped to the public port numbers (8001, 8002, 8003) of the Router.
An external MAXPRO NVR client can access the MAXPRO NVRs using the following settings:
Server IP: 199.63.245.84
Server Port: 8001
Controller IP: 199.63.245.84
Controller Port: 8002
Storage Engine IP: 199.63.245.84
Storage Engine Port: 8003
Scenario 2: Services mapped to existing ports
Single NVR is configured behind the router, and all the services on the NVR are running on the
default ports. In the router's port forwarding section specify the default ports. The Internet
client can just specify the public IP Address and default ports to connect to the NVR. The
drawback of mapping to the same ports is that only one NVR can be behind the router.
MAXPRO NVR Operator's Guide
Figure 2-4 Port Forwarding Scenario 1
• Trinity Server
• Trinity Controller
• Storage Engine
Note:
The mapping of the ports 8001, 8002, 8003 to the respective ports (20007, 26026,
1000) helps an external MAXPRO NVR Internet client to connect to the MAXPRO
NVR system.
L O G G I N G O N A N D F A M I L I A R I Z A T I O N
Logging on using Profiles
23