Advertisement
INSTALLATION
Customer information: The information in this
installation instruction is intended for use only by
skilled technicians who have the proper tools,
equipment, and training to correctly and safely add
equipment to your vehicle. These procedures
should not be attempted by "do-it-yourselfers."
1.
Make sure you have the anti-theft code for the
radio, then write down the frequencies for the
preset buttons.
2.
Disconnect the negative cable from the battery.
Removing the Parts
3.
Wrap a shop towel around a flat-tip screwdriver,
and insert it into the grooves in the audio panel.
Pull the audio panel out toward you to release the
five clips and remove the audio panel. Take care
not to damage the clips.
5 CLIPS
AUDIO
PANEL
FLAT-TIP
SCREWDRIVER
2 of 5
GROOVES IN
AUDIO PANEL
2624042K
AII 43483 (1010)
4.
Remove the four washer-screws fastening the
audio unit to the instrument panel and pull the
audio unit out. Unplug the vehicle connector and
antenna lead from the rear of the audio unit and
remove the audio unit.
VEHICLE
CONNECTOR
AUDIO
UNIT
WASHER-SCREW
(Reuse.)
5.
Remove the four screws and two self-tapping
screws fastening the right and left brackets to the
audio unit and pocket, and separate the pocket
from the audio unit. Save the pocket, screws, and
brackets for your customer.
WASHER-
SCREWS
LEFT
(Reuse.)
BRACKET
SELF-
TAPPING
SCREW
POCKET
(not reused)
© 2010 American Honda Motor Co., Inc - All Rights Reserved.
2828211K
ANTENNA
LEAD
RIGHT
AUDIO UNIT
BRACKET
WASHER-
SELF-
SCREW
TAPPING
(Reuse.)
SCREW
2626010K
Advertisement
