Advertisement
Quick Links
http://www.HandA-Accessories.com
INSTALLATION
INSTRUCTIONS
PARTS LIST
VCP
(Video Cassette Player)
VCP console
Right VCP bracket
Left VCP bracket
Monitor console
Monitor bracket
© 2001 American Honda Motor Co., Inc - All Rights Reserved.
Accessory
in -VEHICLE
ENTERTAINMENT SYSTEM
(i-
VES)
P/N 08A60-S0X-100
AII 22054 (0104)
Y0581D3
Application
ODYSSEY
Butterfly bracket
2 Headphones
(AAA batteries not included)
Remote control
Wire harness
4 Console clips
2 Washer-screws, 5 x 14 mm
4 Self-tapping-screws, 4 x 19 mm
Lock nut
Cushion tape
10 Wire ties
2 Bolts, 8 x 25 mm
Publications No.
AII 22054
Issue Date
APRIL 2001
1 of 14
08Z03-S0X-1A00-91
Advertisement
Related Manuals for Honda in-VEHICLE ENTERTAINMENT SYSTEM 08A60-S0X-100
Summary of Contents for Honda in-VEHICLE ENTERTAINMENT SYSTEM 08A60-S0X-100
- Page 1 4 Self-tapping-screws, 4 x 19 mm Lock nut Monitor console Cushion tape 10 Wire ties Monitor bracket 2 Bolts, 8 x 25 mm 1 of 14 08Z03-S0X-1A00-91 © 2001 American Honda Motor Co., Inc - All Rights Reserved. AII 22054 (0104) Y0581D3...
-
Page 2: Installation
Remove the template. Using a utility knife, cut out the marked areas of the headliner. Remove and discard the cut pieces of the headliner and the insulation. CONSOLE i-VES HARNESS 2 of 14 AII 22054 (0104) © 2001 American Honda Motor Co., Inc - All Rights Reserved. - Page 3 With Navigation Unit: CONSOLE PANEL CONNECTORS PLASTIC COVER NAVIGATION UNIT SCREWS With Navigation Unit: NAVIGATION UNIT CONNECTORS CLIP ANTENNA LEAD SCREW CONSOLE PANEL 3 of 14 © 2001 American Honda Motor Co., Inc - All Rights Reserved. AII 22054 (0104)
- Page 4 10. Open the center lower pocket, and remove the six self-tapping screws. Disconnect the connector (if equipped), and remove the center lower pocket. 4 of 14 AII 22054 (0104) © 2001 American Honda Motor Co., Inc - All Rights Reserved.
- Page 5 (lift up to release the left stoppers. three clips). STOPPER Lower completely. PASSENGER'S GLOVE FRONT DOOR SIDE SILL TRIM CLIP (3) 5 of 14 © 2001 American Honda Motor Co., Inc - All Rights Reserved. AII 22054 (0104)
- Page 6 LOWER ANCHOR BOLT TORQUE: 32 Nžm (24 lb-ft) (Note the sequence of washers. Tape the washers together to RETAINING TAB prevent them from being disrupted.) 6 of 14 AII 22054 (0104) © 2001 American Honda Motor Co., Inc - All Rights Reserved.
- Page 7 23. Remove the sunvisor on the passenger's side (two Torx bolts, and unplug the connectors). Unplug the vehicle connectors. LENS TORX BOLTS RETAINING SUNVISOR 7 of 14 © 2001 American Honda Motor Co., Inc - All Rights Reserved. AII 22054 (0104)
- Page 8 CENTER TABLE 16-PIN CONNECTOR (BLACK) i-VES CENTER HARNESS PILLAR NUTS FLOOR Route inside the CARPET floor panel. 8 of 14 AII 22054 (0104) © 2001 American Honda Motor Co., Inc - All Rights Reserved.
- Page 9 BRACKET monitor console. Turn the bracket clockwise 4 x 19 mm to lock it into position. SELF-TAPPING SCREWS 9 of 14 © 2001 American Honda Motor Co., Inc - All Rights Reserved. AII 22054 (0104)
- Page 10 HARNESS i-VES HARNESS 20-PIN CONNECTORS WIRE TIE i-VES HARNESS VEHICLE HARNESS 20-PIN CONNECTOR WIRE TIES i-VES HARNESS 20-PIN CONNECTOR VEHICLE HARNESS 14-PIN CONNECTOR 10 of 14 AII 22054 (0104) © 2001 American Honda Motor Co., Inc - All Rights Reserved.
- Page 11 46. Install the right VCP bracket using two of the self-tapping screws removed in step 10; then secure the lower bracket with two plain washers, and one 8 mm flange nut. 11 of 14 © 2001 American Honda Motor Co., Inc - All Rights Reserved. AII 22054 (0104)
- Page 12 FM modulator frequency switch setting: Adjust only switches 3, 4, and 5. Factory Default 88.1MHz 88.3MHz 88.5MHz 88.7MHz FM MODULATOR 88.9MHz 89.1MHz 89.3MHz 89.5MHz 12 of 14 AII 22054 (0104) © 2001 American Honda Motor Co., Inc - All Rights Reserved.
- Page 13 58. Install the accessory socket and socket holder LEFT VCP removed in step 11 onto the VCP console. BRACKET ACCESSORY SOCKET CONSOLE POWER FILTER SOCKET HOLDER 13 of 14 © 2001 American Honda Motor Co., Inc - All Rights Reserved. AII 22054 (0104)
- Page 14 69. Press the speaker switch on the VCP . 70. Test for system as described in the Owner’s Manual supplied. 71. Reinstall all removed parts. 72. Reset the clock. 14 of 14 AII 22054 (0104) © 2001 American Honda Motor Co., Inc - All Rights Reserved.