Advertisement
Quick Links
INSTALLATION
INSTRUCTIONS
PARTS LIST
Cassette player
Owner's manual
5 Washer-screws
Wire tie (not used)
Harness clip
TOOLS REQUIRED
Phillips screwdriver
Small flat-tip screwdriver
INSTALLATION
1.
Make sure you have the anti-theft code for the radio,
then write down the frequencies for the preset
buttons.
2.
Disconnect the negative cable from the battery.
© 2002 American Honda Motor Co., Inc - All Rights Reserved.
Accessory
CASSETTE PLAYER
P/N 08A03-5B1-050
3.
AII 24113 (0208)
Application
ODYSSEY (EX)
Remove the console cover:
•
Move the gear selector lever to the 1 position.
For 2003-2004 Modells See
Pages 4 & 5 for updated
removal instructions
•
Pull out on the console panel, unplug the
connectors, and remove the panel.
CONSOLE PANEL
SMALL
FLAT-TIP
SCREWDRIVER
Publications No.
AII 24113
Issue Date
AUG 2002
CONNECTOR
CLIPS (10)
TABS (10)
COVER
1 of 3
08A03-S0X-1001-91
Advertisement
Related Manuals for Honda 08A03-5B1-050
Summary of Contents for Honda 08A03-5B1-050
- Page 1 Make sure you have the anti-theft code for the radio, SMALL then write down the frequencies for the preset FLAT-TIP buttons. SCREWDRIVER Disconnect the negative cable from the battery. AII 24113 (0208) 1 of 3 08A03-S0X-1001-91 © 2002 American Honda Motor Co., Inc - All Rights Reserved.
- Page 2 Set the pocket aside, it will not be reused. BUS CABLE 5 x 8 mm HARNESS CLIP WASHER- SCREW 2 of 3 AII 24113 (0208) © 2002 American Honda Motor Co., Inc - All Rights Reserved.
- Page 3 NOTE: If the radiator fan comes on during this step, the time when it is operating must not be included in the 5 minutes. CLIP CONSOLE PANEL COVER AII 24113 (0208) 3 of 3 © 2002 American Honda Motor Co., Inc - All Rights Reserved.
- Page 4 2003 Odyssey Audio Panel Removal Updated Procedure 1. Insert a small screwdriver 3. Repeat procedure on other into left side of storage bin side of storage bin. between it and the panel. Cover the screwdriver with ei- ther thin cloth or electrical tape to protect the panel 4.
- Page 5 8. With the panel loose remove 5. Slide one hand up the side the wiring connectors from the of the panel, pulling to release back of the panel the next clip. 6. Repeat the procedure on the left side of the panel http://www.HandA-Accessories.com 7.