Table of Contents
Advertisement
700 Series Managed Switch User's Guide for Software v2.1
When the interface command is properly entered, you will be taken to the Interface Configuration
Mode, where the prompt changes from
to
FSM726(config)#
FSM726(config-if)#.
When you are done configuring one particular interface and wish to configure another interface,
you must exit the Interface Configuration Mode by using the
command. You then have to
exit
re-enter Interface Configuration Mode by specifying another interface, again, using the
command
interface
When you're in interface configuration mode, you will be able to configure the following items.
CoS (Class or Service)
Class of Service (CoS) is a way of managing traffic in a network by treating different types of
traffic with different levels of service priority. Higher priority traffic gets faster treatment during
times of switch congestion.
Syntax
FSM726(config-if)# cos <normal/high>
Where
= the priority given to the port. When set to high, traffic from and destined for
<normal/high>
this port will take priority over traffic from other ports.
Description
This command allows you to assign a name or description to a port.
syntax
FSM726(config-if)# description <description>
where
= the description you wish to give to this particular interface
<description>
Duplex
Syntax
FSM726(config-if)# duplex <duplex operation>
Where
6-14
Command Line Interface
SM-10004-02
Advertisement
Table of Contents
