Wireless Repeating Function - NETGEAR RANGEMAX WNR3500 User Manual

NETGEAR RangeMax™ Wireless-N Gigabit Router WNR3500 User Manual
In the scenario shown, the following conditions must be met for both APs:
• Both APs must use the same SSID, wireless channel, authentication mode (if any), and
encryption mode (see information about WEP in
page 2-9").
• Both APs must be on the same LAN IP subnet. That is, all the AP LAN IP addresses are in the
same network.
• All LAN devices (wired and wireless computers) must be configured to operate in the same
LAN network address range as the APs.
• If you are using DHCP, the Get Dynamically From ISP Gateway radio button in the Internet
IP Address section of the Basic Settings screen should be selected for all AP devices in the IP
Address Source section.

Wireless Repeating Function

You can view or change wireless repeater settings for the wireless router. From the main menu of
the browser interface, under Advanced, click Wireless Repeating Function to display the
Wireless Repeating Function screen.
Figure 4-7
4-12
"Configuring WEP Wireless Security" on
v1.0, March 2008
Customizing Your Network Settings