Table of Contents
Advertisement
2
3
1. Battery charger
2. Battery cartridge
3. Charging light
Charging
004513
1. Plug the battery charger into the proper AC voltage
source. The charging light will flash in green color.
2. Insert the battery cartridge so that the plus and minus
terminals on the battery cartridge are on the same sides
1
as their respective markings on the charger. Insert the
cartridge fully into the port so that it rests on the charger
port floor.
3. When the battery cartridge is inserted, the charging light
color will change from green to red and charging will
begin. The charging light will remain lit steadily during
charging.
4. When the charging light color changes from red to
green, the charging cycle is complete.
5. If you leave the battery cartridge in the charger after the
charging cycle is complete, the charger will switch into
its "trickle charge (maintenance charge)" mode.
6. After charging, unplug the charger from the power
source.
7. Refer to the table below for the charging time.
Battery type
1822
1833
1834
1835
NOTE:
•
The battery charger is for charging Makita battery
cartridge. Never use it for other purposes or for other
manufacturer's batteries.
•
When you charge a new battery cartridge or a battery
cartridge which has not been used for a long period of
time, it may not accept a full charge. This is a normal
condition and does not indicate a problem. You can
recharge the battery cartridge fully after discharging it
completely and recharging a couple of times.
•
If you charge a battery cartridge from a just operated
tool or a battery cartridge which has been left in a
location exposed to direct sunlight or heat for a long
time, the charging light may flash in red color. If this
occurs, wait for a while. Charging will begin after the
battery cartridge cools. The battery cartridge will cool
Capacity (Ah)
Number of cells
2.0
2.2
2.6
3.0
Charging time
15
Appprox. 45min.
15
Appprox. 50min.
15
Appprox. 60min.
15
Appprox. 70min.
003267
9
Advertisement
Table of Contents
