Table of Contents
Advertisement
1
2
3
1. Screw
2. Miter scale
3. Pointer
1
1. Arm holder
2. Arm
3. 0° bevel angle adjusting bolt
4. Lever
1
1. Triangular rule
2. Saw blade
3. Top surface of turn base
24
Make sure that the pointer points to 0° on the miter
002210
scale. If the pointer does not point to 0°, loosen the
screw which secures the pointer and adjust the pointer
so that it will point to 0°.
2. Bevel angle
(1) 0° bevel angle
002858
4
2
3
001819
2
3
Push the carriage toward the guide fence and
tighten the clamp screw on the turn base to secure
the carriage. Lower the handle fully and lock it in the
lowered position by pushing in the stopper pin.
Loosen the lever at the rear of the tool.
Turn the 0° bevel angle adjusting bolt (lower bolt) on
the right side of the arm two or three revolutions
counterclockwise to tilt the blade to the right.
Carefully square the side of the blade with the top
surface of the turn base using the triangular rule,
try-square, etc. by turning the 0° bevel angle adjust-
ing bolt clockwise. Then tighten the lever securely.
Advertisement
Table of Contents
