Table of Contents
Advertisement
1
1. Cut grooves with blade
1
1. Stopper Pin
22
set plate with the screw. When the set plate is not used,
loosen the screw and turn the set plate out of the way.
NOTE:
•
Use of the holder-rod assembly (optional accessory)
allows cutting repetitive lengths up to 2,200 mm
approximately.
7. Groove cutting
001563
A dado type cut can be made by proceeding as follows:
Adjust the lower limit position of the blade using the
adjusting screw and the stopper arm to limit the cutting
depth of the blade. Refer to "Stopper arm" section
described on previously.
After adjusting the lower limit position of the blade, cut
parallel grooves across the width of the workpiece using
a slide (push) cut as shown in the figure. Then remove
the workpiece material between the grooves with a
chisel. Do not attempt to perform this type of cut using
wide (thick) blades or with a dado blade. Possible loss of
control and injury may result.
CAUTION:
•
Be sure to return the stopper arm to the original position
when performing other than groove cutting.
Carrying tool
002193
Make sure that the battery cartridge is removed. Secure the
blade at 0Åã bevel angle and the turn base at right miter
angle fully. Secure the slide poles after pulling the carriage
toward you fully. Lower the handle fully and lock it in the low-
ered position by pushing in the stopper pin.
Carry the tool by carrying grip as shown in the figure. If you
002221
remove the holders, dust bag, etc., you can carry the tool
more easily.
CAUTION:
•
Always secure all moving portions before carrying the
tool.
•
Stopper pin is for carrying and storage purposes only
and not for any cutting operations.
Advertisement
Table of Contents
