Functional Description - Makita pj7000 Instruction Manual

7. Check the blades carefully for cracks or
damage before operation. Replace cracked or
damaged blades immediately.
8. Make sure that the flange fits in the arbor hole
when installing the blade.
9. Inspect for and remove all nails or foreign
matter from the workpieces before operation.
10. Always place the workpieces on a stable
workbench.
11. Secure the workpieces firmly with clamp or
vise.
12. NEVER wear gloves during operation.
13. Hold the tool firmly with both hands.
14. Keep your hands and body away from the
grooving area.
15. Run the tool for a while without the blade
pointing toward anybody. Watch for vibration
or wobbling
installation or a poorly balanced blade.
16. Never reach your hands underneath the
workpieces while the blade is rotating.
17. Do not leave the tool running unattended.
18. Always be sure that the tool is switched off
and unplugged
adjustments or replacing the blade.
19. Some material contains chemicals which may
be toxic. Take caution to prevent dust
inhalation and skin contact. Follow material
supplier safety data.
20. Do not use blunt or damaged blades.
21. Do not use the tool with damaged guards.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to safety rules for the subject product. MISUSE or
failure to follow the safety rules stated in this
instruction manual may cause serious personal
injury.
that could indicate
before making

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function on
the tool.
Adjusting the depth of groove
3
poor
012682
6 grooving depths can be preset according to the size of
biscuit to be used.
Refer to the table below for the correspondence
between the sizes marked on the stopper and the biscuit
size. Fine adjustments to the grooving depth can be
any
made by turning the adjusting screw after loosening the
hex nut. This may become necessary after the blade has
been resharpened a few times.
Size on stopper
Biscuit size
Depth of groove 8 mm 10 mm 12.3mm
* With the rubber spikes removed.
012681
Angle guide
The angle guide height can be moved up and down to
adjust the position of the blade in relation to the top of
the workpiece.
1
6
7
2
3
012254
To adjust the angle guide height, loosen the lock lever
down and rotate the knob until the pointer points to the
desired scale graduation marked on the angle guide.
4
1
4
2
0 10 20
0 10 20
13 mm
5
4
1. Pointer
2. Stopper
3. Adjusting screw
4. Rubber spike
S D MAX
- - -
*
14.7mm 20 mm
1. Lock lever
2. Angle guide
3. Knob
4. Scale
5. Pointer
6. Tighten
7. Loosen