OfficeServ 7200-S
TECHNICAL MANUAL
3) Push the front panel lever of the interface board until the board is completely inserted
into the OfficeServ 7200-S slot.
3.3.2 Replacing Boards
If the OfficeServ 7200-S system fails to operate normally due to an error on the power supply
board, control board, or interface board, replace the board with a new one.
Removing Cables
Replace a board after removing all cables connected to the board.
The procedure for replacing a board installed in a slot of a cabinet is as follows:
POWER TO THE CABINET MUST BE TURNED OFF. Failure to do so will damage the
card, cabinet and/or corrupt the data moving along the data bus.
1) Turn off the power of the cabinet.
Figure 3.12 Front Panel Lever
Figure 3.13 Turning the Cabinet Power Off
3.11
Home Page
INSTALLATION
PART 3 MAY 2010