Operation By The User; Select Temperatures - Honeywell DHC 23 Operating Instructions Manual

DHC 23

OPERATION BY THE USER

Select temperatures

Select room temperature
The setpoint for the room temperature can be set with the aid of the room temperature
knob between 8°C and 32°C.
The room setpoint can also be set with the remote control TF 26.
In the normal operating mode, the set room temperature is maintained during the
set heating times, in the continuous heating mode constantly.
If you want to heat outside the set heating times, you must set the operating mode
switch to .
If you do not want to heat within the set heating times, you must set the operating mode
switch to or .
Select domestic hot water temperature
⁄
!
Warning:
With domestic hot water temperatures above 60°C there is danger of scalding at
all domestic hot water taps (kitchen, bathroom ...). You must then mix cold water
sufficiently.
The domestic hot water temperature can be set with the aid of the domestic hot water
temperature knob between 35°C and 75°C.
The set setpoint is always the cut-in value. The domestic hot water charging is
completed after reaching a switching difference (+ 5 K).
In the normal mode, continuous heating mode and domestic hot water rea-
diness modes, this temperature is controlled during the set times of domestic hot
water readiness, domestic hot water heating is switched off in between.
If you want to have domestic hot water at other times (e.g. early in the morning), you
must change the times of domestic hot water readiness (see Adjustment by the
user chapter).
7