Makita BCL140 Instruction Manual page 5

009993
Now point suction inlet downwards, turn capsule in
direction of arrow in diagram, and disconnect capsule
slowly and straight.
NOTE:
Dust may spill out when capsule is opened, so be
•
sure to set a garbage bag beneath capsule.
1
009994
Remove accumulated dust from inside of capsule and
off of prefilter.
1
009995
Twist prefilter in direction of arrow to unfasten securing
lip from cleaner unit and then pull off prefilter.
1
009996
1. Capsule
2. Suction inlet
1
2
1. Prefilter
2. Capsule
2
1. Prefilter
2
2. Securing lip
1. Prefilter
2. Filter
2
Clean out fine dust from prefilter. Next, remove filter, and
lightly tap to dislodge dust.
Reassembly
1
009997
Put on filter until it is fully in position on the cleaner unit.
NOTE:
Make sure filter is put on straight without being
•
peeled back. If filter is put on incorrectly as shown
in diagram, dust will get into motor housing, and
cause motor failure.
1
010005
Connect prefilter. At this time, make sure to twist prefilter
so that securing lip is firmly locked into cleaner unit.
1
009999
010000
5
1. Prefilter
1. Filter
1. Prefilter