Hitachi E100 Safety Instructions And Instruction Manual page 12

English
ACCESSORY
ASSEMBLING THE WHEEL KIT
1. Checking of supplied accessories
2. Tool preparation
• Hoist or square bar (100 mm by 100 mm, length: 700 mm)
• Plier
• Spanner or socket wrench (12 mm), 2 units
3. Assembly procedures
(1) Raise the generator by about 100 mm, with hoist or with square bar put under the bottom panel.
(2) Attach wheel mounting parts 1, 2, stopper 9, using clamp =, 8 and wheel 3, to wheel shaft 4.
Then check that wheel 3 is rotated smoothly. If moving turns out to be too complicated, assemble
them together using grease. (4 locations / 2 pieces)
(3) Bend the tip of 1 according to the shape of wheel shaft 4 as possible.
(4) Attach the assembled shaft to the foundation plate of the engine, using 5, 7, and 8.
(5) Attach the other shaft to the foundation plate of the generating unit, using 6 and 7. (8 is not used.)
The tightening torque of bolts should be 20 to 25 Nm (2.0 to 2.5 kg-m).
CAUTION:
For your safety, don't fail to fix the wheels with wheel brakes for the prevention of
moving.
Don't operate the generator set at an inclined foundation.
NOTES ON INSTALLATION
1. If you provide the generator with wheels, always be sure to place
the generator on a level surface, locking the wheel with the stopper
and/or chocking the wheels.
2. Select a place which allows you to maintain and inspect the
generator, which is not exposed to contamination caused by
exhaust gas.
If you are planning to install the generator without its wheels
attached, consider the work efficiency in terms of an oil change.
3. In ground connection, be sure to use the designated ground terminal.
(A grounding cable is not included in the set of accessories.)
4. During use, be sure not to disconnect the battery.
5. While the power is on, do not unplug the unit or disconnect cables
from the terminals.
12
Fig. 5
Unlock
Stopper
Lock
Fig. 6