Engine And Shaft Disassembly And Assembly - Makita ER2650LH Technical Information

R
epair
[4] DISASSEMBLY/ASSEMBLY
[4]-2. Engine and Shaft
DISASSEMBLING
(1) Disconnect lead wire and grounding wire by removing each connector after Air cleaner cover is removed. (Fig. 1)
(2) Remove Control cable from Insulator by loosening nuts of the adjust screw and disconnecting inner cable
from Swivel of Carburetor. (Fig. 2)
Fig. 1
Connector (4pcs.)
(3) Loosen two M5x18 Hex socket head bolts on Pipe holder and remove M5x12 Hex socket head bolt. (Fig. 3)
(4) Pull out Shaft pipe complete from Engine (Pipe holder). (Fig. 4)
Note: Cover cloth on a shaft and pull out it by grasping it with Waterpump pliers in case the shaft is stuck
at the spline engagement. (Fig. 5).
Fig. 3
M5x13 Hex.
socket head bolt
M5x18 Hex.
socket head bolt (2pcs.)
Fig. 5
cloth
Shaft Water pump pliers
ASSEMBLING
Take the reverse step of disassembly. Set Control cable in place. (Fig. 2, Fig. 6)
Fig. 6
Hook the tip end of Inner cable in the groove of Swivel on Carburetor and
fix Control cable in the Cable holder of Insulator by tightening Nuts of Control cable.
Note: Adjust the tension of the cable to allow the play 1mm to 2mm.
Tip end of Inner cable to be hooked
on Swivel
Adjust screw
Nuts to fix
in Cable holder
of Insulator
Control cable
Fig. 2
Inner cable
of Control
cable
Cable
holder of
Insulator
Fig. 4
Pipe holder
Insulator
Inner cable
Swivel
Adjust screw of
Control cable
Nuts of Control
cable
Shaft pipe Shaft
Pipe holder
Shaft pipe complete
Swivel
P 3/ 14