Playback - Honeywell hr960 Manual

Load a pre-recorded tape.
1
AUTO PLAY :If a cassette with the erasure prevention tab removed is loaded, the unit
automatically begins playback.
Press the PB / REC SPEED (+) or(–) buttons to select the desired playback mode.
2
Press the PLAY button to start playback.
3
Press the STOP button to stop playback.
4
The modes with the letter "L" (i.e. L6H, L18H, L30H) are for audio recording and playback on
the linear track.
• NTSC(PAL)*
PLAYBACK MODE L6H
Audio playback Available Available

PLAYBACK

AUDIO PLAYBACK
L18H L30H 48 H
Available Not Available Not Available Not
72 H 120H 168 H 240H 480H 960 H
Not Not Not
N O T E
* Select the VIDEO setting on "VCR SET
UP" menu to COLOR or B/W according
to the playback video signal type.
* If too much noise appears in B/W
playback mode of B/W monitor, convert
to color mode. Then you can view more
clear picture.
N O T E
* When the picture shakes up and down
when above 18H of PLAYBACK, the
shaking can decrease by the control of
V. LOCK.(Refer to V. LOCK on page 26).
* There is normal sound playback only
when a tape recorded in theLinear REC
modes is played back in its respective
mode.
* If a recording is played back in a higher
Not
REC/PB mode than it was recorded, the
picture will be played back in slow
motion, and if a recording is played back
in a lower mode than it was recorded,
the picture will be played back in fast
motion.
* The picture may move up / down or
noise may occur when the tape is played
back in time lapse modes, such as
L18H, L30H or longer.
* If you want playback with audio, please
set up the audio button to "ON"
condition.
English-21