Settings Related To The Waiting Time; Setting The Waiting Time For Manual Feeding [Timeout For Manual Feeding] - Fujitsu fi-6800 Operator's Manual

Chapter 8 Operational Settings

8.6 Settings Related to the Waiting Time

Setting the Waiting Time for Manual Feeding
[Timeout for manual feeding]
When you scan by manually loading one sheet at a time
(Manual feeding mode), you can specify the waiting time
(interval) for feeding the next sheet, in which scanning can be
continued.
When the specified time elapses, the scan is automatically
stopped and manual feeding is canceled.
To cancel Manual Feeding mode immediately, press the
[Counter Reset] button during the timeout period.
1
Start up the Software Operation Panel.
Refer to "8.1 Starting Up the Software Operation Panel" (page
2
From the listing on the left, click [Device Setting 2] 
[Timeout for manual feeding].
132).
3
Specify a value of the timeout for manual feeding.
To enable the timeout setting, select the timeout period for manual
feeding until loading the next document after the previous one.
The scanner waits for the period of manual feed

timeout even if scanning starts with no document
loaded on the hopper.
This setting can also be configured from the operator

panel.
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Replacing
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
177