Adjusting The Result Of The Output Image [Overcrop/Undercrop] - Fujitsu fi-6800 Operator's Manual

Chapter 8 Operational Settings
Adjusting the Result of the Output Image
[Overcrop/Undercrop]
You can adjust the output image result for documents detected
in Automatic Page Size Detection.
1
Start up the Software Operation Panel.
Refer to "8.1 Starting Up the Software Operation Panel" (page
2
From the listing on the left, click [Device Setting 2] 
[Overcrop/Undercrop].
3
Adjust the output result by using the slider bar.
Item
Overcrop Adds black areas around the edges of the document
so that it contains the whole image.
Specify in the range of 0 to 5 mm (in increments of 1
mm).
132).
Undercrop Deletes the area around the edges of the document
and leaves no black area.
Specify in the range of -5 to 0 mm (in increments of 1
mm).
When you scan a wide document by Overcrop, it may not
add the specified amount of black area around the
document edge.
Output result is not adjusted when the slide bar is set

to 0 mm.
This setting appears ONLY when Kofax VRS (optional)

is used.
Description
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Replacing
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
168