Honda 08A23-2E1-010 Installation Instructions Manual page 8

17. Remove the driver's dashboard lower cover.
• Remove one self-tapping screw.
• Release the four clips on the left side first by
gently pulling out on the driver's dashboard
lower cover.
• After releasing the four clips, insert the tip of
the screwdriver between the clip and the
dashboard frame. Gently twist the screwdriver
to release each clip.
• Unplug the vehicle connector, and remove the
lower cover.
VEHICLE
CONNECTOR
CLIP
(Release
these
clips first.)
DRIVER'S
SELF-
DASHBOARD
TAPPING
LOWER COVER
SCREW
18. If equipped, remove the driver's dashboard under
cover (release the three retaining clips, one pin
and one holder).
HOLDER
RETAINING
CLIPS (3)
8 of 20
CLIP
CLIPS (7)
2206121K
DRIVER'S
PIN
DASHBOARD
UNDER COVER
2705440T
AII 24046 (0208)
19. Pry up on the four retaining tabs that fasten the
cap to the left front door sill and remove the cap.
IGNITION
KEY
KEY
CYLINDER
20. Remove the self-tapping screw. Insert the ignition
key into the key cylinder and turn it clockwise until
it will no longer turn. Using a flat-tip screwdriver,
pry up on the key cylinder and remove it from the
left front door sill.
21. Remove the left front door sill (five clips and two
retaining tabs).
LEFT FRONT
DOOR SILL
FRONT
© 2002 American Honda Motor Co., Inc - All Rights Reserved.
CAP
SELF-TAPPING
SCREW
RETAINING
TABS (4)
LEFT FRONT
DOOR SILL
2131020T
CLIPS (5)
RETAINING
TABS (2)
2131010T