Cisco PIX 500 Series Configuration Manual page 430

Transferring an Image onto an SSM
hostname# hw-module module slot recover configure
where slot is the slot number occupied by the SSM.
Complete the prompts as applicable. If you are modifying a configuration, you can keep the
•
previously configured value by pressing Enter. The following example shows the prompts. For more
information about them, see the entry for the hw-module module recover command in the
Security Appliance Command Reference.
Image URL [tftp://0.0.0.0/]:
Port IP Address [0.0.0.0]:
VLAN ID [0]:
Gateway IP Address [0.0.0.0]:
Note
After you complete the series of prompts, the adaptive security appliance is ready to transfer the
image that it finds to the SSM at the specified URL.
Step 2 To transfer the image from the TFTP server to the SSM and restart the SSM, use the hw-module module
recover command with the boot keyword:
hostname# hw-module module slot recover boot
where slot is the slot number occupied by the SSM.
Step 3 Check the progress of the image transfer and SSM restart process with the show module command. For
details, see the
When the adaptive security appliance completes the image transfer and restarts the SSM, the newly
transferred image is running.
If the SSM supports configuration backups and you want to restore the configuration of the application
Note
running on the SSM, see the documentation of the specified SSM for details.
Cisco Security Appliance Command Line Configuration Guide
22-20
Be sure the TFTP server you specify can transfer files up to 60 MB in size. Also, be sure the
TFTP server can connect to the management port IP address that you specify for the SSM.
"Checking SSM Status" section on page
Chapter 22 Managing the AIP SSM and CSC SSM
22-18.
Cisco
OL-12172-03