Cisco PIX 500 Series Configuration Manual page 971

Chapter 43 Troubleshooting the Security Appliance
rommon #1> ADDRESS=10.132.44.177
rommon #2> SERVER=10.129.0.30
rommon #3> GATEWAY=10.132.44.1
rommon #4> IMAGE=f1/asa800-232-k8.bin
rommon #5> PORT=Ethernet0/0
Ethernet0/0
Link is UP
MAC Address: 0012.d949.15b8
Be sure that the connection to the network already exists.
Note
Step 5 To validate your settings, enter the set command.
rommon #6> set
ROMMON Variable Settings:
ADDRESS=10.132.44.177
SERVER=10.129.0.30
GATEWAY=10.132.44.1
PORT=Ethernet0/0
VLAN=untagged
IMAGE=f1/asa800-232-k8.bin
CONFIG=
LINKTIMEOUT=20
PKTTIMEOUT=4
RETRY=20
Step 6 Ping the TFTP server by entering the ping server command.
rommon #7> ping server
Sending 20, 100-byte ICMP Echoes to server 10.129.0.30, timeout is 4 seconds:
Success rate is 100 percent (20/20)
Load the software image by entering the tftp command.
Step 7
rommon #8> tftp
ROMMON Variable Settings:
ADDRESS=10.132.44.177
SERVER=10.129.0.30
GATEWAY=10.132.44.1
PORT=Ethernet0/0
VLAN=untagged
IMAGE=f1/asa800-232-k8.bin
CONFIG=
LINKTIMEOUT=20
PKTTIMEOUT=4
RETRY=20
tftp f1/asa800-232-k8.bin@10.129.0.30 via 10.132.44.1
Received 14450688 bytes
Launching TFTP Image...
Cisco PIX Security Appliance admin loader (3.0) #0: Mon Mar
Loading...
After the software image is successfully loaded, the adaptive security appliance automatically exits
ROMMOM mode.
To verify that the correct software image has been loaded into the adaptive security appliance, check the
Step 8
version in the adaptive security appliance by entering the following command:
OL-12172-03
Using the ROM Monitor to Load a Software Image
Cisco Security Appliance Command Line Configuration Guide
5 16:00:07 MST 2007
43-11