HP 8360 User Handbook Manual page 315

HP 8360
User's Handbook
SWEep : STEP value is (StopMAX-StartMIN) /lO
SWEep:TIMEMINimum
SWEep:TIME:AUTO ON
SWEep:TIME:LLIMit 10ms
SWEep : GENerat ion ANALog
SWEep : MODE AUTO
SWEep : MANual : POINt 1
SWEep:MARKer:STATe OFF
SYSTem:ALTernate:STATe OFF
SYSTem:COMMunicate:GPIB:ADDRess 19
SYSTem:KEY:ENABle SAVE
SYSTem:MMHead:SELect:AUTO ON
SYSTem:SECurity:COUNt 1
UNIT:AMPCT *UNIT:POWerDBM
l
The present instrument state is stored in the specified memory
register. The acceptable numeric range is from 1 to 8. An execution
error occurs if you try to save state 0.
l l
Sets and queries the value of the Service Request Enable Register.
l
Queries the Status Byte. This is a non-destructive read.
l
This command performs the same function as the Group Execute
Trigger command defined by IEEE 488.1.
*TST?
l
A full selftest is performed, without data logging or looping, and
returns one of the following error codes:
Error Code Definition
0
Test passed.
Test failed.
1
2
Test not run yet. (This is an unlikely event.)
3
Test aborted.
4
Can not execute the test.
5
Can not execute the test, test skipped.
Unrecognized result, software defect.
-1
This causes the synthesizer to wait for the pending commands to
be completed before executing any other commands. For example,
Operating and Programming Reference S-17