Use Of The Command Tables - HP 8360 User Handbook Manual

Use of the Command Tables

In Table 1-4, notice that a new column titled "Allowed Values" has
been added to the command table. This column lists the specific
values or range of values allowed for each parameter. A vertical
bar (I) separates values in a list from which you must choose one
value. The commands listed in the table are only part of all the
available SCPI commands of the synthesizer. For a complete listing
of the programming codes see "SCPI Command Summary" in the
Operating and Programming Reference chapter that follows.
Table 1-4. Sample Synthesizer Commands
Command Parameters
to cal
measured power
801 freq-
correction pairs
center freq
CW freq
coupled to
center freq
free mode
start freq
auto freq step
stop freq
MARKer[n]
marker frequency
Parameter Type
discrete
extended numeric
extended numeric
extended numeric specified freq
range
specified freq range
extended numeric
or MAXimum]MINimum]UP]DOWN
Boolean
discrete
extended numeric specified freq range
or MAXimum]MINimum]UP]DOWN
Boolean
20 to 0.01 dB or
extended numeric
extended numeric specified freq range
or
[n] is 1 to 5, 1 is the default
extended numeric specified freq range
or MAXimumlMINimum
Getting Started Programming 1-87
Allowed Values