Mitsubishi Electric MXZ-SM72TAM-U1 Service Manual page 128

13-1-2. PAR-FL32MA
Controller interface
*For explanation purposes, all of the items
that appear in the display are shown.
*All items are displayed when the Reset
button is pressed.
Fan Speed button (Changes fan speed)
Airflow button (Changes up/down airflow direction)
Mode button (Changes operation mode)
Instructions for use
• When using the wireless remote controller, point it towards the receiver on the indoor unit.
• If the remote controller is operated within approximately three minutes after power is supplied to the indoor unit, the
indoor unit may beep three times as the unit is performing the initial automatic check.
• The indoor unit beeps to confirm that the signal transmitted from the remote controller has been received.
Signals can be received up to approximately 7 meters in a direct line from the indoor unit in an area 45 to the left and
right of the unit.
However, illumination such as fluorescent lights and strong light can affect the ability of the indoor unit to receive sig-
nals.
• If the operation lamp near the receiver on the indoor unit is blinking, the unit needs to be inspected. Consult your deal-
er for service.
• Handle the remote controller carefully. Do not drop the remote controller or subject it to strong shocks.
In addition, do not get the remote controller wet or leave it in a location with high humidity.
• To avoid misplacing the remote controller, install the holder included with the remote controller on a wall and be sure
to always place the remote controller in the holder after use.
13-1-3. PAR-SL101A-E
Controller interface
OCH800A_128
Remote controller display
ON/OFF button
Temperature setting buttons
Check button
Test Run button
Transmission area
Transmission indicator
Timer indicator
Operation areas
Timer Off button
Timer On button
Hour button
Minute button
Set Time button (Sets the time)
Louver button (Changes left/right airflow direction)
Reset button