Siemens SIMATIC S7-1500 System Manual page 150

Configuring
9.4 Display in the TIA Portal
You can copy/add/delete the components of the SIMATIC Drive Controller individually or
together. If you subsequently configure a SINAMICS Integrated, you need to assign the
SINAMICS Integrated manually to the master system to establish the PROFIdrive Integrated
connection.
Figure 9-5
Topology view
As the topology view is irrelevant for the SINAMICS Integrated, only the CPU of the SIMATIC
Drive Controller is displayed.
Device view
There is a separate device view for each of the two components of the SIMATIC Drive
Controller.
• CPU device view: Parameter assignment of the CPU including communication interfaces
• SINAMICS Integrated device: Configuration of the SINAMICS S120 drive components (Line
Modules, Motor Modules, motors, etc.), drive frames, etc.
You can switch between the two views simply and easily with a link.
As in the network view, different content is shown in the Inspector window depending on the
selection in the device view.
148
Display in the TIA Portal – network view
SIMATIC Drive Controller
System Manual, 11/2023, A5E46600094-AD