HP 8340B Manual page 187

9.
The
test menu
name and the
tests
that
can be
run
are displayed. Select the appropriate
softkey:
[Input #]
lets you
enter
the number of the test you wish to
run.
[Auto Sequence] lets you select which tests to run automatically. When you select the tests
([ON]
or [All on] then [Execute]), the program automatically loads the first test. At the end of each test,
the next test
is
loaded. This
saves
returning to the test menu after each test.
[LoopTest]
lets you run the selected test (test the
cursor
is pointing to) as
many times as you
wish. You can change the cursor position
with the
computer's rotary knob, or
up/down keys.
[PrevPage] is not implemented
in
this
software.
[Utility]
lets you
access the test menu
utilities (see section
8
for detailed information on how to
use the utilities described below). The utilities you
can choose from
are:
•
Change the DUT option configuration cal constants (used
when
retrofitting options).
•
Display or
print
the stored measurement data from any of the tests
you have run.
•
Display or
print the test status for any
instrument you have tested.
[SELECT]
selects the test at which the cursor is pointing. You can change the cursor position with
the computer's rotary knob or up/down
keys.
[NextTest] automatically selects the
next
test
to
be run.
[NextPage] is not implemented
in this
software.
[Exit] exits
you from this menu.
10.
Select the desired test or utility and refer to the appropriate chapter.
Attenuator Calibration and Operation Verification Test Software
Testing an HP 8340A/B
or
HP 8341A/B
7.3/7-4