Table of Contents
Advertisement
404
7-2. Steps to take in an emergency
Turn the compressor switch on
21
and wait for an approximately 5
seconds, and then turn it off.
Check the tire inflation pres-
sure.
If the tire inflation pressure is
1
under 130 kPa (1.3 kgf/cm
or bar, 19 psi): The puncture
cannot be repaired. Contact
your Toyota dealer.
If the tire inflation pressure is 130 kPa (1.3 kgf/cm
2
or higher, but less than the specified air pressure: Proceed to
step
.
22
If the tire inflation pressure is the specified air pressure (P. 434):
3
Proceed to step
Turn the compressor switch on to inflate the tire until the specified
22
air pressure is reached. Drive for about 5 km (3 miles) and then
perform step
Attach the air release cap to the
23
end of the hose.
If the air release cap is not
attached, the sealant may leak and
the vehicle may get dirty.
Store the bottle in the luggage compartment while it is connected to
24
the compressor.
Taking precautions to avoid sudden braking, sudden acceleration
25
and sharp turns, drive carefully at under 80 km/h (50 mph) to the
nearest Toyota dealer for tire repair or replacement.
2
.
23
.
20
2
or bar, 19 psi)
Advertisement
Table of Contents
