Siemens SINUMERIK 840D Programming Manual page 41

12.97
08.99
1
• In screenforms of drilling and milling cycles, certain
parameters may be input as absolute or incremental
values. The abbreviation ABS for absolute and INC
for incremental values is displayed behind the input
field. You may switch between them with the
"Alternative" softkey. This setting will remain with the
next call of these screenforms.
• With the MMC103 you may display additional
information on the individual cycle parameters by
means of the online help. If the cursor is placed
on a parameter and the help icon
displayed on the bottom right-hand side of the
screen, the help function can be activated.
By pressing the info key the
parameter explanation is
displayed from the Cycle
Programming Guide.
 Siemens AG 2000 All rights reserved.
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide, Cycles (PGZ) - 04.00 Edition
1.5 Cycle support in the program editor (SW 5.1 and later)
i
is
General
1
Alter-
native
1-41