Siemens SINUMERIK 840D Programming Manual page 287

03.96
5
Alarm number
61604
61605
61606
61607
61608
61609
61610
61611
61612
62100
62105
 Siemens AG 2000 All rights reserved.
SINUMERIK 840D/840Di810D/FM-NC Programming Guide, Cycles (PGZ) - 04.00 Edition
Alarm text
"Active tool violates
programmed
contour"
"Contour incorrectly
programmed"
"Error on contour
preparation"
"Starting point
incorrectly
programmed"
"Wrong tool point
direction
programmed"
"Form incorrectly
programmed"
"No infeed depth
programmed"
"No intersection
found"
"Thread cannot be
recut"
"No drilling cycle
active"
"Number of columns
or rows is zero"
Error Messages and Error Handling
5.3 Overview of cycle alarms
Source Explanation, remedy
CYCLE95 Contour violation in relief cut elements
as a result of the clearance angle of the
tool being used, i.e. use a different tool
or check the contour subroutine
CYCLE76 Illegal relief cut element detected
CYCLE77
CYCLE95
CYCLE95 An error was detected during contour
preparation, this alarm is always output
with NCK alarm 10930 ... 10934, 15800
or 15810
CYCLE95 The starting point reached before the cycle
was called does not lie outside the
rectangle described by the contour
subroutine
CYCLE94 A tool point direction between 1 ... 4
CYCLE96 that matches the undercut form must
be programmed
CYCLE94 Check parameters for the undercut
CYCLE96 form
CYCLE76
CYCLE77
CYCLE96
CYCLE95 The system cannot calculate an
intersection with the contour.
Check contour programming or change
infeed depth.
CYCLE97
CYCLE98
HOLES1 No drilling cycle was called modally
HOLES2 before the drilling pattern cycle was
called
CYCLE801
5
5-287