Operating The Cycles Support Function - Siemens SINUMERIK 840D Programming Manual

12.97
1

1.4.8 Operating the cycles support function

Explanation
Carry out the steps below to add a cycle call to a
program:
• Softkey "Support" in the horizontal softkey bar.
• Softkey "Cycle" (MMC 102/103 only).
• Select the cycle via the vertical softkey bar until
the corresponding input screenform appears (the
help display appears on the MMC 100 when you
press the Info key).
• Enter the parameter value.
• With the MMC103, it is also possible to input the
name of a variable instead of a value in the
screenform; the variable name always starts with
a letter or an underscore.
• Hit "OK" to confirm (or "Abort" if the input is
incorrect).
 Siemens AG 2000 All rights reserved.
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide, Cycles (PGZ) - 04.00 Edition
1.4 Cycle support in program editor (SW 4.3 and later)
General
1
1-37