Sony AWS-750 Operating Instructions Manual page 96

[IPv4]
Configure the IP address and other settings for use in IPv4
network environments.
Tap [Apply] after configuring each setting.
[Host Name]: Enter up to 64 alphanumeric characters for
the host name.
[MAC Address]: Displays the unit's MAC address.
[Mode]: Select the mode for the IP address and other
settings.
• [Off]: Do not use IPv4.
• [Manual]: Enter the settings manually. When you
select this mode, enter the IP address, subnet mask,
and default gateway. Use periods (.) as separators
when entering the settings.
• [DHCP]: Automatically configure the settings
using the DHCP server information.
[DNS Mode]: Specify the DNS mode when [Mode] is set
to a setting other than [Off].
• [Off]: Do not use DNS.
• [Manual]: Enter the settings manually. When this is
selected, enter up to 253 alphanumeric characters
for the domain name, and enter the primary DNS
and secondary DNS. The method of entry for the
primary DNS and secondary DNS is identical to that
of the IP address.
• [DHCP]: Automatically configure the settings
using the DHCP server information.
[Apply]: Apply the settings.
[IPv6]
Configure the IP address and other settings for use in IPv6
network environments.
Tap [Apply] after configuring each setting.
96
Configuring System Settings ([System Setup] menu)
[Mode]: Select the mode for the IP address and other
settings.
• [Off]: Do not use IPv6.
• [Manual]: Enter the settings manually. When this is
selected, enter the IP address, default gateway, and
prefix length.
• [DHCP]: Automatically configure the settings
using the DHCP server information.
• [Auto]: Configure the settings automatically.
[DNS Mode]: Specify the DNS mode when [Mode] is set
to a setting other than [Off].
• [Off]: Do not use DNS.
• [Manual]: Enter the settings manually. When this is
selected, enter up to 253 alphanumeric characters
for the domain name, and enter the primary DNS
and secondary DNS. The method of entry for the
primary DNS and secondary DNS is identical to that
of the IP address.
• [DHCP]: Automatically configure the settings
using the DHCP server information.
[Apply]: Apply the settings.
Tip
The [DNS Mode] settings for [IPv4] and [IPv6] are
shared, and the settings that were configured later will be
enabled.
[SNMP]
Configure the necessary settings for managing the unit
with SNMP.
Tap [Apply] after configuring each setting.
[SNMP Agent Service]: Specify whether to enable the
SNMP agent service.
• [Disable]: Disable the SNMP agent service.
• [Enable]: Enable the SNMP agent service. When
this is selected, configure the items as well.
[SNMP MIB-2 Variables]: Enter the MIB-2
information.
• [sysName]: Enter the host name.
• [sysContact]: Enters the administrator name.
• [sysLocation]: Enter the unit's installation location.
[Community Names]: Specify the community names.
• [Read-only Community]: Enter the read-only
community name.