Table of Contents
Advertisement
Videos switch from one to the next.
Tip
Under default conditions, tapping [Take] dissolves
one video into the next using the "mix" transition
method during switching. To instantly switch to the
next video without a transition effect, use [Cut].
[Cut]
For details on selecting transition methods other than
mix, see "Using Transition Effects" (page 30).
Switching the PGM Directly (Direct
Take)
You can also switch the program video directly, without
previewing videos in the [NEXT] viewer. This operation
is referred to as a "direct take."
Direct takes are performed in direct mode.
1
Tap anywhere inside the [PGM] viewer to enter direct
mode.
Tap inside.
Direct mode is enabled, and the [NEXT] viewer
display dims. In direct mode, "Direct Mode" appears
in the [NEXT] viewer.
Dims during direct mode.
2
In the [Input] list, select the input source you want to
use for the program output.
When you select the input source, the program video
switches using the currently configured transition.
3
Repeat step 2 to switch from one video to the next.
For details on selecting other transition methods, see
"Using Transition Effects" (page 30).
Exiting direct mode
Tap anywhere inside the [PGM] viewer again.
When you exit direct mode, the [NEXT] viewer brightens
again.
29
Step 4: Video Switching
Advertisement
Table of Contents
