Step 5: Audio Mixing - Sony AWS-750 Operating Instructions Manual

The default transition rate is 1.0 second.
Tip
If you selected [Cut] in step 3, switching will be
instantaneous regardless of whether you changed the
transition rate.
5
Tap [Take] to execute the transition.
The program video switches using the selected
transition.
For details on changing the values for the [Transition
Rate] options, see "[Transition Rate]" (page 101).

Step 5: Audio Mixing

You can mix the audio being input to the unit and mix it
down to stereo program audio.
Audio operations are performed in the sub screen.
This section describes how to adjust the audio for each
microphone and mix multiple audio channels.
1
Adjust the audio for each microphone.
Adjustments are made separately for each
microphone.
Move the sliders while verifying the audio output and
audio level meter.
2 Drag the sliders for the enabled channel
faders to adjust the audio levels.
1 Tap the channel fader
buttons to which
microphones are assigned
to enable them.
Tips
• You can operate five channel faders at the same
time.
• Channel 5 is reserved for the audio embedded in the
SDI or HDMI video played back in the Media
Player (embedded audio).
For details, see "Adjusting the Embedded Audio of
Input Sources" (page 75).
• A fader can be adjusted even when the channel is
off. The adjustment will be enabled when the
channel is turned on.
• If sound is barely audible even at the maximum
channel fader level, change the MIC/LINE input
level to [Low (-44dB)] in the [Audio Setup] screen.
You can also adjust this in [Input Trim] (page 74)
of the [Access] screen.
Audio level meter
The monitored audio
switches with each tap.
31
Step 5: Audio Mixing