Table of Contents
Advertisement
7-3 Remote key pad specifications
1 Direction keys
(up, down,
left and right)
Key name
*
Direction keys
1
(up, down, left
and right)
Set (select) key
2
(SET)
Cancel key
3
(ESC)
Image change
4
key (SEL)
Measurement
start/brightness
5
select key
(TRG/BRT)
The direction keys have an auto-repeat function (holding them down is the same as pressing
them repeatedly).
Function
Selecting an item on a
menu screen
Setting a window
Setting a value
Determine a highlighted
item
Determine the setting
value
Returning a setting to its
original state before be-
ing changed
Returning to the previous
menu
Switching the image
mode between the
through mode and freeze
mode
Start measurement input
Switching the brightness
level (H and L)
7-9
Setting and Operating Outlines
4 Image change key (SEL)
5 Measurement start/brightness select key
2
Set (select) key (SET)
3 Cancel
key (ESC)
Description
Select an item with the up, down, left and right
keys.
Set each coordinate.
· Select a digit or an item with the left and right
keys, and then specify a value with the up and
down keys.
· Specify a value with the up, down, right and left
keys.
Switch the image mode between through and
freeze on a setting screen. (See the preceding
page.) When the mode is switched from
through to freeze, a new image is captured.
Note: The run screen is only displayed in the
freeze mode, and the "ADJUST GAIN &
OFFSET" screen is only displayed
in the through mode.
Press this key on the run screen, and a new
measurement is triggered.
Change the displayed image brightness. (See
the preceding page.)
· Use this key when the image is so bright that
characters are difficult to see.
· The brightness can be changed on any
screen other than the run screen.
(TRG/BRT)
7
Advertisement
Table of Contents
