Toshiba e-studio200l Service Manual page 475

[ 4 ] Paper jam in saddle stitcher section
[EAB0] Saddle paper transport stop jam
MJ-1025
Is there any paper remaining on the paper transport path in the saddle stitcher section in the
finisher?
YES Æ Remove the paper.
È
NO
Is the connector CN16 (folding position sensor) on the finisher controller PC board discon-
nected?
Is the harness connecting the finisher controller PC board and folding position sensor open-
circuited?
YES Æ Connect the connector securely. Replace the harness.
È
NO
Is the folding position sensor working properly?
NO Æ
È
YES
Replace the finisher controller PC board.
[EAC0] Saddle transport delay jam
MJ-1025
Is there any paper remaining on the paper transport path in the saddle stitcher section in the
finisher?
YES Æ Remove the paper.
È
NO
Is the connector CN16 (folding position sensor) on the finisher controller PC board discon-
nected?
Is the harness connecting the finisher controller PC board and folding position sensor open-
circuited?
YES Æ Connect the connector securely. Replace the harness.
È
NO
Is the folding position sensor working properly?
NO Æ
È
YES
Replace the finisher controller PC board.
June 2004 © TOSHIBA TEC
Replace the sensor.
Replace the sensor.
5 - 45
e-STUDIO200L/202L/230/232/280/282 TROUBLESHOOTING
5