Toshiba e-studio200l Service Manual page 432

[E030] Paper remaining inside the equipment at power-ON
Open the cover of the unit/area whose picture is blinking on the control panel. Is there any
paper on the transport path? (Refer to the following table.)
YES Æ Remove the paper.
È
NO
Is the sensor in the jamming area working? (Perform the input check in the test mode: refer
to the following table.)
NO Æ
l
l
l
l
l
l
l
l
È
YES
Replace the LGC board.
Relation between the jamming area and the corresponding sensors and covers
(If a jam is occurring in the ADU, LCF, PFP, JSP or OCT check the board in each unit.)
Jamming area
Registration area
Exit area
ADU
Feeding area
(Main unit)
LCF
PFP
Bridge unit
JSP
OCT
e-STUDIO200L/202L/230/232/280/282 TROUBLESHOOTING
1) Check if the connector of the sensor is disconnected.
2) Check if any of the connectors on the LGC board is disconnected.
3) Check if the connector pins are disconnected and the harnesses are
open circuited.
4) Check if the conductor pattern on the LGC board is short circuited or
open circuited.
5) Replace the sensor.
6) Replace the LGC board.
Cover
Transfer cover Registration sensor
1st transport sensor
Transfer cover Exit sensor
ADU ADU entrance sensor
ADU exit sensor
Side cover 2nd transport sensor
LCF side cover LCF feed sensor
PFP side cover PFP upper drawer feed sensor
PFP lower drawer feed sensor
Bridge unit Bridge unit transport sensor-1
Bridge unit transport sensor-2
JSP cover JSP feed sensor
OCT cover OCT feed sensor
Sensor
5 - 2
Test mode / Input check
03-[FAX]ON/[2]/[A]
03-[FAX]OFF/[6]/[E]
03-[FAX]ON/[2]/[B]
03-[FAX]OFF/[1]/[H]
03-[FAX]OFF/[1]/[G]
03-[FAX]OFF/[7]/[E]
03-[FAX]OFF/[5]/[G]
03-[FAX]OFF/[2]/[D]
03-[FAX]OFF/[4]/[D]
03-[FAX]ON/[3]/[H]
03-[FAX]ON/[3]/[E]
03-[FAX]ON/[3]/[H]
03-[FAX]ON/[3]/[H]
June 2004 © TOSHIBA TEC