Toshiba e-studio200l Service Manual page 340

[C] Assembling carriage wires (Winding the wire around the wire pulley)
<Procedure>
(1) Pull the Ø3 ball terminal located at the center of the wire into a hole on the wire pulley. One end
of the wire with a hook attached comes to the outside.
(2) Wind the wires around the wire pulleys of the front and rear sides. The number of turns to be
wound are as follows:
• 2 turns toward the opposite side of the boss
• 4 turns toward the boss side
Note: Note:
Pay attention to the following when the wires are wound around the pulleys:
- Do not twist the wire.
- Wind the wires tightly so that they are in complete contact with the surface of the pulleys.
- Each turn should be pushed against the previously wound turn so that there is no space
between them.
2 turns
Ball terminal
Hook
e-STUDIO200L/202L/230/232/280/282 ADJUSTMENT
4 turns
No space between turns
Color: Silver
[Rear]
4 turns
Color: Black
Fig.3-33
3 - 44
2 turns
Ball terminal
Hook
[Front]
June 2004 © TOSHIBA TEC