1 - 6 Omnii Hand-Held Computer with Windows CE 6.0 User Manual
Documents Available
To see a current list of documents and download what you need, please go to the Knowledge Base on the
Motorola IngenuityWorking community website:
http://community.psion.com/knowledge/w/knowledgebase/product-manuals.aspx
Preparing the Omnii for Operation
The Battery
The Omnii is powered by a Lithium-ion Smart Battery pack, 5000 mAh — Model ST3001.
IMPORTANT
Battery packs shipped from the factory are charged to approximately 40% and must be fully charged prior to
use. Batteries can be charged using a variety of chargers and docking stations. For detailed information, see
"Battery Details" on page
Replacing the Battery Pack
IMPORTANT
Omnii Battery
Figure 1-6
1 - Release button
2 - Battery compartment
3 - Guide tabs
4 - Release button tabs
NOTE
If you are using a docking station or an external power supply, you can insert an
uncharged battery and use the device while the battery charges.
Assuming the default power saving parameters and battery reserve level have not been altered, a battery can
be removed for up to 4 minutes without losing data. After 4 minutes the terminal may reboot.
Before charging the battery, it is critical that you review the battery
safety guidelines in the Omnii Hand-Held Computer Regulatory &
Warranty Guide (PN 8000191).
2-3.
Always switch the unit off before changing the battery (see
ing the Omnii On and Off" on page
default power saving parameters and battery reserve level have not
been altered, battery swap time is a minimum of 4 minutes — you
will not lose data if the battery is replaced within this time frame.
2
1
1
"Switch-
1-7). However, assuming the
Battery Top
4
Contacts
3
3
Battery bottom
3
4