Bosch DCN Next Generation Installation And Operation Manual page 236

236 en | Operation
WAP
Use the 7B WAP menu item to open the WAP sub-menu. The menu items in this sub-menu give
general data about the WAP central control unit.
NOTICE!
This data must be mentioned in all service requests and failure reports.
Menu item
7Ba Serial Number
7Bb HW Version
7Bc FPGA Version
7Bd FW Version
Table 8.10 CCU sub-menu (* = default)
8.3 LBB4402/00 Audio Expander
Main
When you start the audio expander, the display first shows Starting. The display then shows
the Main menu item.
NOTICE!
If you do not turn or push the knob for three minutes, the display automatically goes back to
the Main menu item. The display does not automatically go back to the Main menu item from
the 2 Monitoring menu item and its sub-menus.
The Main menu item contains:
–
DCN-NG_IOM_V4.1 | V1.3 | 2012.07
Value
e.g. 1E00271F
e.g. 02.00
e.g. 04.00.3909
e.g. 04.00.4026
The name of the audio expander. The default name is Analog Expander. You can change
the name with the 4E Unit Name menu item (refer to Section 7.4 LBB4402/00 Audio
Expander). Eight VU meters that show the volume levels of the audio inputs and audio
outputs of the audio expander (refer to Section 7.2 19 inch units). When an control input
is disabled, an X character replaces the VU meter of the corresponding audio input or
audio output on the display.
Installation and Operation manual
Description
The hexadecimal serial number of the central
control unit.
The version number of the hardware of the
central control unit.
The version number of the FPGA firmware of
the central control unit.
The version number of the firmware of the
central control unit.
Bosch Security Systems B.V.
Conference System