Chapter 2. Configuring Your Network; Lan Configuration - D-Link DWC-1000 User Manual

Wireless Controller

Chapter 2. Configuring Your Network

To enable management access for the browser based web GUI access or SNMP manager,
you must connect the controller to the network. The default IP address/subnet mask of
the controller management interface is 192.168.10.1 / 255.255.255.0 and DHCP server
on the LAN is disabled by default on the controller. You must connect the controller to
a 192.168.10.0 network.
After you configure network information, such as the IP address and subnet mask, and
the controller is physically and logically connected to the network, you can manage and
monitor the controller remotely through Web browser, or an SNMP -based network
management system. Once the initial setup is complete, the DWC-1000 can be managed
through wired interface connected to controller.

Access the controller's GUI for management by using any web browser, such
as Microsoft Internet Explorer or Mozilla Firefox.
Go to http://192.168.10.1 (default IP address) to display the controller's
management login screen.
Default login credentials for the management GUI:

Username: admin

Password: admin

If the controller's LAN IP address was changed, use that IP address in the
navigation bar of the browser to access the controller's management UI.
2.1

LAN Configuration

Setup > Network Settings > LAN Setup Configuration
By default, in the controller the Dynamic Host Configuration Protocol (DHCP) mode
is set to "None". The DHCP mode can be set as a DHCP server or DHCP relay. When
DHCP mode is DHCP server, the controller functions as a DHCP server to assign IP
address leases to hosts on the WLAN or LAN. With DHCP, PCs and other LAN devices
15
User Manual